| Cookie |
In order to use the quote
service you must accept a cookie from us. Our cookie is only
used to carry your session id as you travel around our
site so we know who you are. |
| Part
Number: |
Enter your part number (numbers
or letters accepted). Include a revision level in your part
number to minimize confusion on reorders. |
| Reorder?: |
Select "No"
if this is the first order for this part or revision. Select
"Yes" if you are reordering a previously ordered part |
| Layers: |
Select the number of copper layers
in your PCB. Currently, we are quoting up to 6 layer online.
|
| Material: |
FR4 epoxy/glass laminate is standard
for our prototype service. |
| Thickness: |
Select the board thickness. .062"
is standard. |
| Copper
Weight: |
Select base copper weight. 1 oz.
is typical (1 oz. = .0014" thick). We plate an additional
.001" (approx.) on outer layers during fabrication. |
| Finish: |
Select "Solder" for standard
Solder Mask Over Bare Copper with HASL (hot air solder level)
finish. Also select "Solder" for tin/lead plate if
no solder mask is to be applied.. Select "All Gold"
for Immersion Gold (fine pitch applications.) |
| Board Length: |
Enter overall length of board
in inches.
Note: Either dimension can be used for length or width. |
| Board Width: |
Enter overall width of board in
inches.
Note: Either dimension can be used for length or width. |
| Hole
Count: |
Enter approximate number of holes
in board. |
| All Holes
Plated Thru? |
Select "Yes"
if all holes are plated through. |
| Smallest
Hole: |
Select the smallest drilled hole
in board. |
| Minimum Trace/Space: |
Select the minimum trace width
or minimum space between traces; whichever is smaller. |
| SMD
Pads (top): |
Enter the total number of Surface
Mount Device pads on the top side of the board. |
| SMD
pads (bot.): |
Enter the total number of Surface
Mount Device pads on the bottom side of the board. |
| Min. SMD pitch: |
Select the smallest SMD pitch on
the board, measured center to center between pads. |
| Gold
Fingers: |
Select the number of board edges
having gold fingers. An edge is that portion of the board which
is inserted into a connector. |
| Solder Mask: |
Select the number of sides to be
solder masked. Our standard mask is green LPI. |
| Color |
Select Solder Mask Color - Green
is standard. |
| Silkscreen: |
Select the number of sides to receive
silk-screened legend. Our standard is white epoxy ink. |
| Color |
Select Silkscreen Color - White
is standard. |
| Cutouts/ Slots: |
Total number of internal cutouts.
Count any hole over 0.025" as a cutout. Count internal
slots. External slots less than 0.125" should be counted. |
| Web
Route: |
Select no and we will ship your
parts individually routed. Select yes if you want your parts
shipped in panel form held together by small routed tabs. The
parts can be snapped apart after assembly. |
| Test |
Enter "Yes" if you want
your boards electrically tested. Testing checks for opens and
shorts compared to your Gerber files. The number of holes and
SMT pads affect the price of testing. |
